Install 20|20 Monitor in Cab

Find what you need to install your 20|20 monitor in the cab. Use the five-step process for simple installation.

Updated June 29, 2020

Diagram showing a 20|20 monitor mounted on the right-hand side of a cab
Diagram showing a 20|20 monitor mounted on the right-hand side of a cab

Step 1: Optimal visibility and interaction

Mount your display(s) anywhere in the cab that provides optimal visibility and interaction.

Diagram showing a 20|20 monitor mounted on the front right-hand side of a cab and a Display Base Module mounted in the back right-hand side
Diagram showing a 20|20 monitor mounted on the front right-hand side of a cab and a Display Base Module mounted in the back right-hand side

Step 2: Install Display Base Module (DBM)

Mount your Display Base Module (DBM) in any convenient and secure cab area. Plug provided ethernet cord(s) into the port and connect to the display.

Diagram showing a Power Harness plugged into power on one end and the DBM on the other
Diagram showing a Power Harness plugged into power on one end and the DBM on the other

Step 3: Connect power

Connect the 725150 Power Harness to the DBM in the four-pin Deutsch connector, as shown. Then connect to the cab’s power source.

Need more adapters? Additional adapters are available to connect to different types of power ports.

Diagram showing Deutsch connections plugged into the back of the DBM
Diagram showing Deutsch connections plugged into the back of the DBM

Step 4: Connect CAN harness

Connect an implement CAN harness into the 12-pin Deutsch connector on the DBM. Place the extra cable length through the cab harness port in the back window.

CAN A: Black Connector

If a Power Distribution Module (PDM) tool is installed, use CAN A.

CAN B: Brown Connector

If you’re only using a Smart Connector, use CAN B.

The 725935 Sensor CAN harness only works with CAN B.

Diagram showing harnesses connected to the back of the DBM
Diagram showing harnesses connected to the back of the DBM

Step 5: Connect speed harness

Connect the 725155 speed harness to the eight-pin Deutsch connector on the DBM; this gives you two four-pin round connections. Then, connect to the GPS adapter and radar adapter.

Using the system only for sensing? If so, the 725155 adapter isn’t necessary. Just plug the 725939 harness directly into the eight-pin Deutsch connector on the DBM.